![how to bounce a traack in place in protools 12 how to bounce a traack in place in protools 12](http://www.newvideo.com/wp-content/uploads/2014/01/How-To-Make-Money-DVD-F.jpg)
The cycle region will then mirror the length of whatever is highlighted. Simply click on the desired track or clip, then press command + U. There is also a handy shortcut when wanting to have a certain track or clip in the cycle region. Hi Don, I think the easiest thing to do in this case would be to record two audio click tracks, so set the click track up as you would normally and route the output to an audio track and then record either a few bar loop (or the length of your session if you really want), and then adjust the click and re-record the new version on another audio track. If you click and drag the edge of the region, the cycle region will lengthen. This will insure synchronicity with all of your tracks. Step 2 - Make your timeline selection to insure the start point and endpoint of the material you would like included from all of your tracks. Once it is on, you can click and drag the region to move it anywhere in the timeline. Using Track Bounce Step 1 - Select all the tracks that need to be exported (track names will be highlighted). To toggle on the cycle region, simply press C on your keyboard. Whatever is outside of that region, will be ignored by Logic. This means that when exporting, anything within the cycle region is what will be exported. When the cycle region is toggled on, anything that is within the region is considered highlighted. The cycle region is a yellow bar towards the top of the screen, right under the control bar. Hide all unused tracks that are not pertinent to the stem-delivery task at hand. Use this visual aid to assist in detecting any noise, clicks or pops before sending your stems. When exporting tracks in Logic, the cycle region is the key. Open your desired session and use Audio Zoom to increase the height of your waveforms. Published by Loop Community on DecemDecember 6, 2019Įxporting your tracks is the last step to get your tracks out and ready to be played back for worship! After exporting, you can then bring them into Prime, MainStage, Ableton, or any other DAW.